Pages

Tuesday, May 22, 2012

Oki c9300n drum resetting

1 - Power ON printer while holding both the + & - buttons until “OKIUSER” message apear in LCD.
2) Press + or – button until “ENGINE DIAG MODE” is displayed;
3) Press "ENTER", will be displayed "DIAGNOSTIC MODE XX.XX.XX S-MODE"
4) Press + or – button until “NV-RAM INITIAL” is displayed
5) Press "ENTER" again;
6) Will appear "TABLE 1" message;
7) Press "ENTER" until "EXECUTING RESET" message appear. the "NV-RAM INITIAL" message will BLINK...
This procedure reset TONER, DRUM, FUSER and BELT...
8) power OFF printer, wait 10 sec, and power ON again... =)

To access Service Mode in C9300 power ON printer with 0, 1, 6, 7 at same time.