Pages

Tuesday, November 13, 2012

error 6A00 on Canon Pixma MP610

Open the cover. There is a Purge unit on the right. Use a flashlight and you will see two ink pads. This is where the printhead is PARKED,.. and is the top of the Purge unit. There are wiper blades that move from the rear to the front that wipe the bottom of the printhead when it is parked (The ink pads actually drop down about 3/4" to allow the wiper to pass,..then it supposed to SPRING back to the rear. All of this, and the ink suction for cleaning the printhead is done by the purge unit,... one of the most complex parts of the printer.


Use some rubber gloves and a paper towel and see if you can press the ink pads down just a little bit, like 1/4". See if for some reason the wipter blade is stuck extended,.. if so see if you can get it unstuck. Don't force anything, just be gentle.The error you are getting is telling you that the purge unit is not giving the correct timing signal as it rotates inside 360 degrees. Therefore, something is either broken or jammed inside. If you had a paper jam and tried to forcefully pull it out, you could have pulled the internal gears out of alignment.


So if you will need to do some maneouvers to try to release the cartridge from its parking position. Dont try hard.


by andy